The three-in-one feeder has high automation, flattening, good feeding precision, high synchronization performance of the punching machine, easy operation, great saving in labor cost and floor space, etc. It has won the favor of more and more stamping customers. . With the increase in demand, there are more and more manufacturers engaged in the production of three-in-one feeders in China, but the quality that comes with them has also been mixed, especially in design and production. problem.
1. The drums are not in the same heart. In the flattening or feeding part, one side is sewn and the other side is sewn and the running edge is taken out. If the three-in-one roller is not the same, it is a big problem. It is a problem with the feeder.
2. The tensioning device is different in tension, and the adjusting material wheel is not adjusted properly. The width of the adjusting guide wheel in the flat feeding part of the feeding material is not adjusted to an appropriate size, and the width of the discharging wheel is not adjusted to an appropriate size. If the three-in-one feeder unwinding part of the material blocking device, the feeding wheel of the flat feeding part, and the feeding wheel of the feeding material are not adjusted, if it is too wide, it will easily go wrong.
3. the positioning of the mold tip is not done, it is very likely that the positioning of the mold.
4. There is a problem with the guiding device of the material frame, and the design is unreasonable. The irrationality of this design can easily lead to accidents. This means that the guiding device is not doing well. The design is unreasonable.